Fast dry marking paints that are designed for streets and parking lots. They may be ambient, airless, conventional, or heated to accelerate the dry time. Normal dry time is 10 minutes at 77 deg. F. at 50% humidity. These meet or exceed the current VOC regulations and to the requirements of Federal Specification TT-P-01952E Types I and II. Use on cured asphalt, concrete, brick, and other street or highway surfaces. Do not paint on wet surfaces. Dries to a flat finish. Covers approximately 300 to 350 sq. ft. per gallon or approximately 320 lineal ft. with 4" stripe. Do not use brush or roller. Apply with Airless Line Sprayer at 1800 to 2700 P.S.I. with .015 to .019" tip or Conventional Line Sprayer (atomization pressure 20 to 80 P.S.I.) Thin with water up to 12.5% by volume if needed. Clean hands and tools immediately after use with soap and warm water. Flush spray equipment with mineral spirits to prevent rusting of equipment.